Starting up where I left off????

Discussion in 'General' started by Regie, Apr 7, 2017.

  1. Regie

    Regie Active Member

    Hello,

    With this new version of SwordSearcher, most often when I close out my work, it will open again with a different module than the one I was working on when I closed down the program.

    I think there is probably a way to set it so it will open with the last module I worked on. Is there?

    Thanks,
    Regie
     
  2. Brandon Staggs

    Brandon Staggs Administrator Staff Member

    It is probably because the module you were on is not set as a favorite/visible module. Go to the tabs menu and choose "select which modules to show." If the module you want to use is checked there, it should "stay open" even when you restart SwordSearcher.